The DFX-6 is extremely easy to use. Specifically designed
for easy operation onstage with color-coded controls.
This mixer was hardly used and is in near perfect condition. Includes owner's manual. Effects
32-bit effects section (derived from Mackie's considerable
digital mixer technology) gives you 9 reverbs - including a great spring reverb
emulation - and 4 delays, optimized for live use. Plus, the DFX-6 gives you
chorus, flange and phaser effects for special sonic treatments. And your DFX-6
mix can be shaped to the room using the built-in 5-band master EQ. Also the effects
can be sent to monitors.
Vocal Eliminator
The DFX-6 features a vocal eliminator circuit that can
remove lead vocals from pre-recorded material. Phase inversion reduces signal
panned to the center of the mix while a notch filter reduces frequencies
between 160Hz and 5kHz which represents the frequency range of the human voice.
The result eliminates vocals well enough for karaoke use.
Superior Sonic Quality
Ultra Low Noise Mic Preamps and quality circuitry reinforces
Mackie's signature low-noise transparent signal quality.
Break Switch
The BREAK switch Mutes all channels eliminating the chance
of any accidental signal while the mixer is unmanned. The only signal allowed
passage is that of the 2 track CD/tape input. This allows intermission music to
be played while all other inputs remain off.
MUTE on all input channels.
Total # Of Inputs: 6 - Balanced 1/4" TRS Phone
Mic/Line Inputs: 6 - Balanced 1/4" TRS Phone 4 - Balanced XLR Mic
Stereo Line Inputs: 2 - (stereo paired) Balanced 1/4" TRS Phone inputs 3-6
AUX Sends: 2 - Balanced 1/4" TRS Phone
AUX Returns: 2 - (L/R paired) Balanced 1/4" TRS Phone
Inserts: 2 - 1/4" TRS Phone channels 1-4
BUS (Group) Outputs: Stereo Main Output Bus Only
2 Trk Master I/O: Stereo RCA (L/R) Input and Output
Monitor Outputs:
L/R - Balanced 1/4" TRS Phone outputs
L/R - Balanced XLR outputs
EQ Section:
Low EQ 80Hz
Hi EQ 12kHz
Low-Cut Filter 18dB/oct @ 75Hz
5 Band graphic EQ on Main Output
Specs:
Channel Level Control: 60mm log-taper faders
Trim/Gain Control: 150-ohm terminated, max gain (mic pre)
Phantom Power: +48v (global phantom power switch)
Metering: 12- Segment peak LED's (L/R)
Frequency Response: 20Hz to 60kHz -0.5/-1.5dB
Signal-to-Noise Ratio: (ref +4) > 90dB
Total Harmonic Distortion (THD): below 0.05% any output, 1Khz @ +14dBu, 20Hz to
20kHz, channel input
Power Supply: Internal 30W
Dimensions: 4.1 x 11.8 x 14.4" (105 x 300 x 365mm) (H x W x D)
Shipping weight will be roughly 20 lbs.
Includes manual
|